Mass edit bin file4/2/2024 Generic NVRAM Driver for MediaTek Board. PandoraBox Mass Storage accelerater v1.2 raeth: PDMA RX ring 512, PDMA TX ring 512. Ralink APSoC Ethernet Driver v3.2.4 (raeth) EEPROM:Read from offset 0xe000,length 0圆. 1 squashfs-split partitions found on MTD device rootfs mtd: device 4 (rootfs) set to be root filesystem mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block - forcing read-only mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block - forcing read-only 3 uimage-fw partitions found on MTD device firmware PandoraBox MT7621/28 SPI flash driver, SPI_ClK: 44MHz Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled MIPS secondary cache 256kB, 8-way, linesize 32 bytes. Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes. Normal zone: 110592 pages, LIFO batch:31 MediaTek MT7621 pkg:BGA rev:1 eco:3 CPU:880MHz Bus:220MHz Uart:50MHz PandoraBox CPUID Module for Ralink/MTK SoC v1.1. |_|īase on OpenWrt BARRIER BREAKER (3., 0.000000] Initializing cgroup subsys cpu | Copyright 2013-2016 D-Team Technology Co.,Ltd.SZ | installed package on overlayfs.īusyBox v1.24.1 ( 13:33:05 CST) built-in shell (ash) I do not like using sysupgrade to restore the whole firmware because it did not restore all the things back, eg. It seems that sysupgrade using 'mtd write' can only write a partition not the whole IC. Is there anyway to flash the full_flash.bin to the router's 16MB SPI flash by linux command insead of the IC flash programmer? If I need restore this backup and my router is bricks, I will using CH341A USB programmer flash the 'full_flash.bin' back to the 16MB SPI NOR flash IC.īut if my router is alive, and I can still ssh access. cat backup_full_bin.shĮcho "Full flash backup store at /tmp/full_flash.bin."Įcho "Full config backup store at /tmp/full_." Every time before flash a new firmware, I always do a full backup for my current running firmware.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |